IFIT

Solid Timber Flooring

What is Solid Timber Flooring

What is Solid Timber Flooring?

Solid timber flooring is milled from a single plank of natural wood — no plywood core, no veneer. It can be sanded and refinished many times over, ageing with character rather than wearing out. It performs best indoors, where humidity and temperature stay fairly consistent.

  • 01 100% Natural WoodMilled from a single solid plank, no layered core.
  • 02 RefinishableSanded and restored multiple times over its life.
  • 03 Long LifespanCan last for generations with proper care.
  • 04 Natural VariationUnique grain pattern in every board.
  • 05 Best IndoorsPerforms best in stable, consistent conditions.
IFIT — Supply & Installation Scope

Supply & Installation Scope

Our timber flooring installation follows a fixed sequence, from sub-floor checks to the final coat, carried out by our in-house installers.

01

Surface Preparation

Screed is cured, levelled and checked before any timber is laid.

  • Step 1 – Surface Preparation: ensuring sufficient curing of screed to a moisture content below 6%

    Moisture check

  • Step 1 – Surface Preparation: checking screed flatness

    Screed flatness

  • Step 1 – Surface Preparation: checking sub-floor surface level

    Sub-floor level

02

Laying Timber Strips

Strips are bonded onto the plywood/cemboard base, cleat-fastened and closed off edge to edge.

  • Step 2 – Laying Timber Strips: applying Megabond adhesive using a steel notched trowel

    Adhesive application

  • Step 2 – Laying Timber Strips: laying the timber strips

    Laying strips

  • Step 2 – Laying Timber Strips: fastened down using PRIMATECH L Cleat nailed at a 45 degree angle

    Cleat fastening

  • Step 2 – Laying Timber Strips: installation of the end piece of strips without a surface nail

    End piece fit

03

Sanding & Varnishing

Multiple sanding passes, gap filling and two coats bring the floor to its final finish.

  • Step 3 – Sanding & Varnishing: sanding in 3 stages using a Lagler Hummel endless belt sanding machine

    3-stage sanding

  • Step 3 – Sanding & Varnishing: sanding edge and stair using a Lagler Elan sanding machine

    Edge & stair sanding

  • Step 3 – Sanding & Varnishing: final sanding using a TRIO 3 disc sanding machine

    Final disc sanding

  • Step 3 – Sanding & Varnishing: using FEIN Multi Master tools to sand and grind the corners

    Corner grinding

  • Step 3 – Sanding & Varnishing: patching all gaps with PW formulation filler

    Gap filling

  • Step 3 – Sanding & Varnishing: applying 1 coat of Strata Base using a floor coater

    Base coat

  • Step 3 – Sanding & Varnishing: removing grain-raising using the SCAD wing buffing machine

    Grain buffing

  • Step 3 – Sanding & Varnishing: applying 2 coats of Strata Pro using a floor coater

    Top coats

Get In Touch

541 Melville Ave, Palo Alto, CA 94301,

Email.Exemple@gmail.com

Phone:  +012.345.6789

Work Inquiries

Email.Exemple@gmail.com

Phone: +012.345.6789